MIRKA PBS 10NV Manual De Instrucciones página 46

en
Maintenance
Always disconnect the air supply before maintenance!
Only use original Mirka spare parts!
Replacing the belt PBS 10
1 . Disconnect the air supply .
2 . Push the tension arm towards the steel protect cover to release the lock function . See Figure 2 .
3 . Open the steel protect cover by loosening the cover knob .
4 . Change the belt, make sure that the belt is centered
5 . Close the steel protect cover by tightening the cover knob
6 . Press the lock function on the tension arm towards the steel cover to engage tension . See Figure 3 .
Figure 2 (Step 2)
Replacing the belt PBS 13
1 . Disconnect the air supply .
2 . Push the plate to open the protect cover .
3 . Keep the plate compressed in order to change the belt, make sure that the belt is centered .
4 . Release the push plate to engage tension .
5 . Close the steel protect cover .
Further service
Servicing must always be performed by trained personnel . To keep the tool warranty valid and ensure optimal tool
safety and function, servicing must be carried out by a Mirka authorized service centre . To locate your local Mirka
authorized service centre, contact Mirka Customer service or your Mirka dealer .
46
Mirka® Pneumatic Belt Sander • PBS 10NV & PBS 13NV
Figure 3 (Step 6)