Setting Up The Pro:centric Network - LG PCS400R Servidor Pro:Centric Instalación Y Configuración

Setting Up the Pro:Centric Network
This section describes how to complete the initial network configuration for the PCS400R. See also typical setup
and VPN network connections diagrams above.
1 If your system is using ASI output, make the following connections; otherwise, go to step 2.
• Connect a 75 ohm BNC-to-BNC coaxial cable between ASI OUT on the PCS400R and ASI IN on the
modulator.
• Connect an RF coaxial cable between IF OUT on the modulator and IF IN on the upconverter.
* Note: The BNC cable must be less than 30 feet (9.2 meters) in length.
2 To enable remote management, connect one end of a CAT5 RJ-45 Ethernet cable to the Control Port on the
PCS400R rear panel, and connect the other end of the cable to the institution's network.
3 Connect the PCS400R power supply to the POWER connector on the PCS400R rear panel. Then, plug the AC
power cord into a powered AC line receptacle. When power is applied, the PWR (Power) LED on the PCS400R
front panel will initially flash red and then turn green (blinking during boot-up).
The boot-up process for the PCS400R may take several minutes. When boot-up is complete, the PWR LED on
the PCS400R front panel will light continuously green.
4 Once the PWR LED is lit continuously (no longer blinking), use the FTDI TTL-232R-5V-AJ cable to connect a PC
to the Service Port on the PCS400R rear panel.
5 Using HyperTerminal or an equivalent terminal emulation program on the PC, configure the serial port as
follows: Bits per second/baud = 115200; Data bits = 8; Parity = None; Stop bits = 1; Flow Control = None
* Note: To avoid configuration errors, make sure the keyboard settings on the terminal emulator assign the
backspace character to Ctrl + H (ASCII 8).
Once the connection is established, you should see a login prompt. (If the login prompt is not automatically
displayed, press Enter to refresh the screen.)
6 At the
* Note: After the initial system setup is complete, it is highly recommended that you change
the admin user password from its default value. See "Change the Login Password" on page
33 for further information.
20
prompt, type and press
(case-sensitive) and press
. Then, at the
.
prompt, type