Function Of Control Terminals; Standard Control Wiring - BONFIGLIOLI Vectron Agile Manual Del Usuario

Function of control terminals

Standard control wiring

X13:
1 2 3 4
> 4k7
X12:
1 2 3 4
X11:
1 2 3 4 5
IND: digital input
MFI: multifunction input
OUTD digital output
OUT2D: digital output 2
MFO1: multifunction output
Run Sig. execution message
Act. Speed: actual speed
Speed ref: setpoint speed
Mot. motor temperature
Sys CAN-systembus
Enable: release
FixedFr. fixed frequency
Dataset Dataset
Relay output relay output fault message
Memory card: slot for optional memory card
Mode: operation mode for X11.6
X: terminal strip
Thermal contact evalu-
ation X12.4
P570 0- off (default)
1- Warning
2- Error switch
off
Agile
Quick Start Guide
 6 digital inputs, 2 of them for
Enable
 1 digital input/ output

2 multifunction inputs:
digital/analogue
 1 digital output
 1 multifunction output:
digital/analogue/frequency
5 6
Act.
Speed
5 6
Relay output
Fault Message
X10:
6
1A DC / 24V
3A AC / 240V
Data set change-over
X11.6 Selection
0 DS1
1 DS2
Switching frequency
X12.1 Selection
0 0 Hz (P480)
1 10 Hz (P481)




X13.1 DC 24 V input
X13.2 GND forX13.1
X13.3 Digital input. Input 2 for enable. Contact
opened: output disabled, motor coast to
a standstill. Contact closed (together
with X11.3): normal operation.
X13.4 DC 10 V output
X13.5 Digital output. Run signal. Indicates out-
put of frequency when enable and start
command applies.
X13.6 Multifunction output. Default: analogue.
Voltage signal proportional to actual
speed. 10 V at 50 Hz,0V at 0Hz.
X12.1 Digital input.
Data set change-over together with
X11.6.
X12.2 Digital input. Error acknowledgment.
X12.3 Multifunction input: digital/analogue.
Default: analogue voltage input. Refer-
ence speed. 50 Hz at DC 10 V, 3.50 Hz at
DC 0 V.
X12.4 Multifunction input: digital/analogue.
Default: digital input. For connection of
motor thermal contact. Set P570.
X12.5 CAN High
X12.6 CAN Low
X11.1 DC 24 V output
X11.2 GND for X11.1
X11.3 Digital input. Input 1 for enable. Contact
opened: output disabled, motor coast to
a standstill. Contact closed (together
with X13.3): normal operation.
X11.4 Digital input. Start clockwise.
X11.5 Digital input. Start anticlockwise.
X11.6 Digital input/output. Default: input. Data set change-over together with X12.1.
Observe the technical data in the
42
1 voltage input DC 24 V
2 voltage outputs,
DC 10 V and DC 24 V
1 relay output
Communication-
interface CAN
Systembus connection.
Refer to the separate man-
ual.
manual.
05/2019