Cognex ISC-7800 Serie Manual página 10

Install the Mounting Bracket (ISB-7000-7K)
The accessory mounting bracket kit (ISB-7000-7K) includes the mounting bracket,
M3 screws (quantity 4) and a hex wrench for attaching the camera to the mounting
bracket. The mounting bracket also has 1/4 - 20, M6 and flathead mounting holes for
mounting the camera to a mounting surface.
CAUTION:
The camera should be grounded, either by mounting the camera to a
l
fixture that is electrically grounded or by attaching a wire from the
camera's mounting fixture to frame ground or Earth ground. If a
ground wire is used, it should be attached to one of the four mounting
points on the back plate of the camera; not to the mounting points on
the front of the camera.
When mounting the camera to the mounting bracket, use the M3
l
screws supplied with the mounting kit. If using the 1/4 - 20 or M6
screw holes on the mounting bracket to secure the camera to a
mounting surface, the insertion depth of the screw should not exceed
7mm. Allowing the mounting screws to bottom in the mounting hole
can damage the camera.
1. Align the mounting bracket with the mounting holes on the camera.
2. Insert the M3 screws into the mounting holes and tighten using a 2.5mm hex
wrench; the maximum torque is 0.90 Nm (8 in-lb).
9