Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Connect the Breakout Cable
The camera's PWR connector supplies power to the camera and provides access to
the camera's acquisition trigger and strobe output.
CAUTION:
To reduce emissions, connect the far end of the Breakout cable
shield to frame ground.
Note:
I/O wiring or adjustments to I/O devices should be performed when
l
the camera is not receiving power.
Exposed wires can be cut short or wire ends trimmed, and the wires
l
tied back using a tie made of non-conductive material. Keep all bare
wires separated from the +24VDC wire.
1. Verify that the 24VDC power supply being used is unplugged and not
receiving power.
2. Optionally, connect the I/O wires to an appropriate device (for example, a
trigger sensor or strobe light).
3. Attach the Breakout cable's +24VDC (Red wire) and GND (Black wire) to
the corresponding terminals on the power supply.
CAUTION:
observe the polarity shown.
4. Connect the Breakout cable's M12 connector to the camera's PWR
connector.
Never connect voltages other than 24VDC. Always
11
Tabla de contenido
