Installing The Ceiling Tube; Assemble The Light On Ceiling Tube - Derungs D med VISIANO 20-2 C T1 Instrucciones De Montaje Y Funcionamiento

Luz de examen
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 48
WARNING
Wear safety equipment according to the tool manufacturer's
instructions.
Drill holes and blow out with a bellows.
135 mm
270 mm
Check the hole distances.
Hold the ceiling bracket to the ceiling and hammer in the
fastening anchor.
Tighten the fastener according to manufacturer's instruc-
tions.
DANGER
Death hazard from electric shock.
Do not turn on the power supply before the luminaire
head has been installed.
This device must only be connected to a power grid
with a protective ground conductor (PE) to prevent risk
of electric shock
Connect the power.

3.4. Installing the ceiling tube

A
Pull the ceiling tube cable through the opening "B" of the
ceiling holder.
Insert the ceiling tube "A" into the ceiling holder.
Secure the safety screw "C"and the M8 nut.
D
Tighten the M8 safety screw "C" and the nut (20 Nm).
Tighten all 4 grub screws "D" (5 Nm).
Connect the secondary cable to the connection point
Pay attention to the polarity:
+ = black
– = white
Slide the ceiling cover and ring over the ceiling bracket
and screw them tight.

3.5 Assemble the light on ceiling tube

WARNING
The light will fall if fastening is done incorrectly
The securing element must be screwed in fully and
correctly.
ENG
B
C
C
19
Tabla de contenido
loading

Este manual también es adecuado para:

D med visiano 20-2 p tx

Tabla de contenido