Delabie TEMPOSTOP Manual Del Usuario página 13

• Once the desired flow rate has been achieved, replace
the coloured marker.
Lever-control model (Fig. J)
• Unscrew the lever and adjust the flow rate on the valve using a
3mm Allen key to achieve the optimal flow rate.
Through-the-wall model (Fig. J)
• Unscrew the valve from the connection nut and turn slightly.
Adjust the flow rate on the valve using a 3mm Allen key to achieve
the optimal flow rate.
TEMPERATURE LIMITATION (mixers) (Fig. G)
For the UK and Ireland we recommend installing an appropriate,
approved thermostatic mixing valve (TMV) to provide safe, temperature
controlled hot water. Where thermostatic mixing valves are installed
the temperature limiter MUST BE REMOVED from all point-of-use
mixers.
Recommended maximum temperature settings are: bidets 38°C,
washbasins and showers 41°C. For all other countries please refer to
the relevant hot water safety guidelines.
The product is delivered with the maximum temperature limiter
engaged. To override it:
• Isolate the water supply.
• Loosen the grub screw at the back of the mixer body using a 4mm
Allen key and remove the temperature selector.
• Prise upwards with a flat-headed screwdriver to remove
the coloured limiter
• Re-assemble and commission in line with the TMV manufacturer's
instructions.
• When used with a TMV, always carry out a cold water failsafe check.
MAINTENANCE
Foreign bodies in the pipework can cause the mechanism to
malfunction; to remove the mechanism unscrew the cartridge using
a 23mm flat spanner (Fig. I).
.
EN