Ventilation; Electrical Connections - Indel Webasto Marine isotherm DR16 Instrucciones Para La Instalación Y El Uso

User Manual

4.2 Ventilation

It is extremely important for the compressor/condensing unit located behind the
refrigerator to be well ventilated so that the fresh air can enter at the bottom and
pass behind the refrigerator, with the hot air being allowed to escape from the top or
sides (Fig.1).
The illustration (Fig.2) shows an example of how the refrigerator housing should be
set.

4.3 Electrical Connections

• In order connect the unit to the vehicle's electrical system, proceed as follows:
• Before turning on the appliance, check to make sure that the voltage of the
electrical system and/or battery complies with that which is indicated on the
unit's data plate.
• Connect the refrigerator directly to the battery or to the relative main switch and
make sure that the system is equipped with an electric device that's capable of
protecting the circuit against possible overcurrents.
If the power supply voltage is different from 12/24Vdc, install a ΔI 0.03A differential
circuit breaker. Avoid connecting the unit via the vehicle's control panel as this could
result in voltage drops.
• The product is supplied with a 10A fuse. A separate switch that simultaneously
disconnects the power cables must be installed upstream from the refrigerator.
Check to make sure that this switch supports the 10A current load.
WARNING! If there is a battery charger, it must be connected to the battery
and never directly to the refrigerator.
All wiring diagrams can be found at the end of the manual
51