Technical Specifications - Hughes & Kettner Tube Tools REPLEX Manual

SINGLE HEAD DELAY: Switches the Single-Head-mode delay
effect off or on.
DUAL HEAD DELAY: Switches the Dual-Head-mode delay effect
off or on.
3. TROUBLESHOOTING
Noise: The REPLEX is an effects device equipped largely with
analog circuitry. Particularly the on-board tube, which is
responsible for the highly desirable tube tone, can generate
audible noise.
Tube: When you power the REPLEX up, the Tube Sat LED will
illuminate until the tube has heated up to operating
temperature. If the tube is already warm, this of course won't
take as long. If the LED does not light up, check the power
supply to verify that it is plugged in.
If the LED continues to illuminate for longer than the standard
heat-up period, the tube is defective and needs to be
replaced.
If you find that the effect generates ugly distortion or sounds
muddy, in all likelihood the tube is worn out and needs to be
replaced.
The tube should be replaced by qualified service technicians
only.

4. TECHNICAL SPECIFICATIONS

Weight with AC power pack
Weight without AC power pack 4.4 lbs / 2 kg
Dimensions
Width 10.07" / 256 mm
Height 3.15" / 80 mm
Depth 8.46" / 215 mm
General electrical specifications
Maximum current consumption 690 mA at 13 volts AC
Maximum power draw 11 VA
Mains power supply Use original power supply only!!
Tube (1) ECC83 or 12AX7A
Input sensitivity -25 dB
Input impedance 1 MW
Output level 0 dB
Impedance 1k O h m
5.2 lbs / 2.35 kg