Kohler K-8030 Guia De Instalacion página 9

Leak Shield
Socket Wrench
With Bit
6. Install the Waterway
Insert the escutcheon into the rough opening. The double ribs of
the leak shields should be facing up.
If any of the leak shields makes contact with an elbow: Enlarge
the hole in the back of the leak shield to 1-1/4" (3.2 cm).
Thread the adapter onto one of the nipples using the provided 11
mm bit, 11 mm or 7/16" socket, extension and socket wrench. Use
masking tape to hold the bit in place, as the bit could fall off and
cause damage.
IMPORTANT! The escutcheon should sit loosely at this point. If it is
tight against the wall, use a longer pipe nipple.
Align the groove in the waterway with the double ribs on the
leak shield.
Press the waterway into place over the adapter. Secure the
waterway to the adapter with the screw provided.
Verify that the escutcheon does not turn or shift.
Kohler Co.
Adapter
Extension
Waterway
Screw
9
Escutcheon
1057619-2-E