Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3M™ Super Close Projection System SCP715/740/717
WARNING
To reduce the risk associated with hazardous voltage:
•
Do not remove any screws other than those specified in the lamp replacement instructions;
•
Disconnect power cord when the projector is not in use, during lamp replacement and while cleaning;
•
Switch power "OFF" and disconnect the plug from electrical outlet before replacing the lamp. Grasp plug and pull to
disconnect;
•
Do not attempt to service the projector; other than the lamp cartridge there are no user serviceable parts inside the
projector;
•
Do not attempt to service the projector other than performing routine lamp replacement. Service should only be per-
formed by a 3M authorized service provider. Aside from the projection lamp assembly, there are no serviceable parts
inside the unit;
•
Contact a 3M authorized service provider for service;
•
Do not modify this projector;
•
Do not allow water or other liquids to enter the projector;
•
Do not operate this projector in wet environments or outdoors;
•
Do not use this projector around unsupervised children.
To reduce the risk associated with hazardous voltage and/or fire:
•
Replace power cord if damaged;
•
Contact a 3M authorized service provider if the projector becomes damaged;
•
Connect this projector into a grounded outlet;
•
Use a grounded extension cord with a rating at least equal to that of the projector;
To reduce the risk associated with hot lamp surface:
•
Unplug the projector from the electrical outlet and allow the lamp to cool for 60 minutes before replacing the lamp;
•
Wait at least 30 minutes for the lamp assembly to cool before replacing;
To reduce the risk associated with ruptured lamp:
•
Always handle the fragile lamp module with care;
•
In the event of a lamp rupture, call a 3M authorized service provider for repair. Ruptured lamp is not user serviceable;
•
Ventilate the area where the lamp rupture occurred. The lamp operates at high pressure and temperature;
•
Replace the lamp module when the lamp replacement message appears;
•
Never replace the lamp module with a previously used lamp module.
To reduce the risk associated with mercury exposure and environmental contamination:
•
Hg: Lamp contains mercury. Don't throw in trash. Dispose according to local, state, or federal laws. See www.lampre-
cycle.org or call 1-800-328-1371;
•
Wash your hands thoroughly if contact with ruptured lamp debris has taken place;
•
Ventilate the area where the lamp rupture occurs. The lamp operates at high temperature.
To reduce the risk associated with choking:
•
Keep the battery and battery cover away from children and pets.
CAUTION
To reduce the risk associated tripping or impact:
•
Position the power cord and data cable so that they can not be tripped over.
To reduce the risk associated with impact of a falling projector:
•
Use only the 3M brand wall mounting hardware kit if wall mounting is desired;
•
Installation of 3M wall kit must only be performed by qualified personnel;
•
Adhere strictly to the proper installation procedure as outlined in the installation instructions when installing the 3M wall kit;
•
Always operate the unit on a flat, sturdy, and horizontal surface.
To reduce the risk associated with fire and chemical exposure:
•
Use only battery type AA;
•
Orient the batteries plus (+) and (-) terminals of the batteries according to the markings found on the remote control;
•
Do not leave the battery in the remote for an extended period of time;
•
Do not heat, disassemble, short, recharge, or expose to fire or high temperature;
•
Do not carry batteries loose in your pocket or purse;
•
Avoid eye and skin contact in the event that battery would leak;
•
Do not mix used and new batteries.
To reduce the risk associated with environmental contamination:
•
Dispose of exhausted batteries in accordance with applicable federal, state and local regulations.
To reduce the risk associated with lamp intense visible light:
•
Avoid looking directly into projector lens while the lamp is on.
2
Product Safety Guide
© 3M 2008. All Rights Reserved
English
Tabla de contenido
