Idiomas disponibles
Idiomas disponibles
Descriptions of Other Blinking Patterns
Connection Status LED Charging Status LED
Blinks red three times
rapidly
Blinks red and green
alternatively
Solid red
Updating Firmware
The Do-It-All Handle must be attached to DJI Pocket 2 in order for the
Wireless Mic to connect to DJI Pocket 2 to update its firmware. If an update
is available, the firmware of the Do-It-All Handle will be updated first.
Afterwards, the Wireless Mic links and connects with the Do-It-Handle. A
prompt will appear onscreen with instructions on how to update the firmware
of the Wireless Mic.
Refer to the DJI Pocket 2 Do-It-All Handle User Guide for more
information on how to update firmware.
DO NOT operate the DJI Pocket 2, Do-It-All Handle, or Wireless
Mic while updating firmware. Otherwise, the update may fail.
Specifications
Transmission Type
Acoustic Principle
Polar Pattern
Equivalent Input Noise 24 dB SPL (A-Weighted)
Frequency Range
External Mic Input
Maximum SPL
Dynamic Range
Battery Life
Analog Input
Blinks red three times
rapidly
Blinks red and green
alternatively
Solid yellow
2.4GHz digital frequency
Pre-polarized pressure transducer
Omnidirectional
50Hz - 20kHz
20Hz - 20kHz
130dB SPL 10% THD; 120dB 1% THD
SPL-Equivalent Input Noise (Mic Preamplifiers)
Up to 7 hours
3.5mm input
Descriptions
Battery level is low
and device is about to
power off
Updating Firmware
There is an error and
the Wireless Mic
must be powered on.
Contact DJI Support if
the issue persists.
7
