Idiomas disponibles
Idiomas disponibles
Compliance Information
FCC Compliance Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
This device must accept any interference received, including interference that may
cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Information
SAR tests are conducted using standard operating positions accepted by the FCC/ ISEDC with the
device transmitting at its highest certified power level in all tested frequency bands, although the SAR
is determined at the highest certified power level, the actual SAR level of the device while operating can
be well below the maximum value, in general, the closer you are to a wireless base station antenna, the
lower the power output.
Before a new model device is a available for sale to the public, it must be tested and certified to the
FCC/ ISEDC that it does not exceed the exposure limit established by the FCC/ ISEDC, Tests for each
device are performed in positions and locations as required by the FCC/ ISEDC.
For face-up,0mm was used for test, this equipment should be installed and operated with minimum
distance 0mm
For body worn operation, this model device has been tested and meets the FCC / ISEDC RF exposure
guidelines when used with an accessory designated for this product or when used with an accessory
that contains no metal and that positions the handset a minimum of 0mm from the body.
Non‐compliance with the above restrictions may result in violation of RF exposure guidelines.
ISED Compliance Notice
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada's licence-exempt RSS(s).
Operation is subject to the following two conditions: (1)This device may not cause
interference.(2)This device must accept any interference, including interference that
may cause undesired operation of the device.
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d'Innovation, Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence. L'exploitation est autorisée
aux deux conditions suivantes :(1)L'appareil ne doit pas produire de brouillage; (2)
L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.
ISED Radiation Exporsure Statement
Les tests SAR sont effectués en utilisant des positions de fonctionnement standard
acceptées par la FCC / ISEDC avec l'appareil transmettant à son niveau de puissance
certifié le plus élevé dans toutes les bandes de fréquences testées, bien que le SAR soit
déterminé au niveau de puissance certifié le plus élevé, le niveau SAR réel de l'appareil le
fonctionnement peut être bien inférieur à la valeur maximale, en général, plus vous êtes
proche d'une antenne de station de base sans fil, plus la puissance de sortie est faible.
14
frequency
