Uline FENDALL 2000 Manual Del Usuario página 7

ALARM MAINTENANCE:
CHANGING THE BATTERY
1. Push the blue
button and hold
for 3 seconds
until a beep is
heard to disarm
the alarm.
(See Figure 34)
NOTE: The battery must be replaced after each
use or approximately every 2 years, whichever
occurs first, or when a low battery warning is
heard (a short beep once every 10 seconds).
2. To remove the front
panel to replace
the battery, use
a screwdriver or
pen to push on
release button and
gently pull door
open. Remove
nozzle from its
compartment
and pull headrest
towards you. Push
nozzle and tube
inside unit, under
cartridge.
(See Figure 35)
EMPTYING WASTE RESERVOIR AND REMOVING CARTRIDGE
1. Following use and after an injured person has
sought medical attention, disarm the alarm by
pressing and holding the blue button for 3 seconds
until a beep is heard. Drain waste reservoir by
placing an 8-gallon bucket under waste reservoir
and open drain spout (turn to the right). If desired,
a hose may be placed over the end of the drain
spout to assist in emptying the contents of waste
reservoir. (See Figure 39)
PAGE 7 OF 27
MAINTENANCE CONTINUED
Figure 34
Figure 35
3. To change battery,
remove the front
panel and lay
it on a flat
surface, with the
inside face up.
(See Figure 36)
4. Unscrew screws 1 and 2 to remove the alarm
housing cover. Refer to sticker on alarm housing for
battery maintenance information. (See Figure 37)
1
2
Figure 37
5. Remove the existing 9V industrial battery and replace
it with a new one. Put alarm housing cover back and
reinsert screws 1 and 2. (See Figures 37-38)
WARNING! Short beep once every 10 seconds
indicates a low battery.
Figure 39
8-Gallon
Bucket
Figure 36
Figure 38
Drain
Spout
0621 IH-3838