Idiomas disponibles
Idiomas disponibles
Cleaning and Storing
1. Do not store chemicals in the tank. If the chemical is stored in the tank, it can clog the system as it dries and
destroy the seals and other components.
2. To prolong its life, clean the sprayer after each use. After using water-based products, rinse thoroughly with
soapy water then clean water, being sure to flush out the hose and flow control. After spraying solvent or
oil-based products, follow the chemical manufacturers' recommended cleaning procedure, following up with
a thorough rinsing and flushing of the sprayer, hose and flow control with soapy water then clean water.
3. To store the sprayer, remove the complete hose assembly (hose w/siphon tube, wand, flow control) from the tank.
4. For proper drainage and drying, lock flow control lever on.
5. Loosen pump assembly, but leave in the tank.
6. Store all components in a clean, dry area.
TROUBLESHOOTING
Always depressurize the sprayer, remove all chemical solution and clean the sprayer before making repairs. Replacement
parts may be purchased at the store where the sprayer was purchased or they can be ordered from our PRO Hot line
at 1-866-967-7677.
PROBLEM: Pump works hard or does not pressurize the tank.
CAUSE: Plunger o-ring either not lubricated or damaged.
SOLUTION: Apply petroleum jelly or similar lubricant around outside of plunger o-ring. Check for cracks or other damage
and replace if necessary.
PROBLEM: Spray solution or air leaks into pump cylinder.
CAUSE: Check valve on bottom of cylinder is prevented from sealing by dirt, residue or damage.
SOLUTION: Remove the pump assembly and examine the check valve. Clean if dirty; replace if necessary.
PROBLEM: Hose leaks air at tank connection.
CAUSE: (1)Tank nut is loose or (2) hose insert o-ring is damaged.
SOLUTION: (1) Tighten hose tank nut or (2) replace hose insert o-ring.
PROBLEM: Flow control leaks.
CAUSE: Improper assembly or cracked.
SOLUTION: Refer to "Assembly for Wand" instructions, replace if necessary.
PROBLEM: Bad spray pattern or low spray volume.
CAUSE: (1) Nozzle is clogged or (2) low pressure in sprayer.
SOLUTION: (1) Remove nozzle and clean; remove wand and clean. If wand cannot be unclogged, replace it or (2)
repressurize the tank.
PROBLEM: Nozzle leaks when flow control is closed.
CAUSE: Flow control remaining open (lever is locked on).
SOLUTION: Completely disassemble flow control. Inspect all components, clean and lubricate all seals or replace flow
control.
PROBLEM: Leak at tank opening.
CAUSE: (1) Pump assembly not sealed tightly into tank or (2) dry or damaged pump cylinder gasket or o-ring.
SOLUTION: (1) Thoroughly clean pump cylinder gasket or o-ring and surrounding area and apply grease or petroleum
jelly to pump gasket or o-ring or (2) Replace gasket or o-ring.
Root-Lowell manufacturing Co. warrants to the original purchaser only that this product will continue to function as
intended if used in accordance with the operating instructions for as long as the original purchaser owns the product. If
the product fails to function as intended—DO NOT RETURN TO THE STORE—call out Consumer Hotline at 1-800-253-4642
(toll free) for fast service. We will, at our option, repair or replace any non-functioning parts without charge—shipping
charges will apply. Root-Lowell Manufacturing Co. shall have the option of requiring the return of the non-functioning
product to the address listed below together with the proof of purchase to establish a claim under this warranty. This
warranty does not apply to damage resulting from accident, misuse, neglect, alterations, operation not in accordance with
instructions, or normal wear or o-rings or seals. NOTE: Rubber seals and gaskets require periodic maintenance, and
are not warrantable once they come in contact with chemicals. ANY IMPLIED WARRANTIES, INCLUDING THE IMPLIED
WARRANTY OF MERCHANTABILITY AND FITNESS FOR CONSUMER USE, ARE SOLELY LIMITED TO THE DURATION
SPECIFIED ABOVE. ROOT-LOWELL MANUFACTURING CO.'S LIABILITY IS LIMITED SOLELY TO THE REPAIRS OR
REPLACEMENT OF THE NON-FUNCTIONING PRODUCT OR PART. ROOT-LOWELL MANUFACTURING CO. EXCLUDES
LIABILITY UNDER THIS WARRANT FOR ANY AND ALL INCIDENTAL AND CONSEQUENTIAL LOSS OR DAMAGE. Some
states do not allow limitations on how long an implied warranty lasts, or the exclusion or limitation of incidental or conse-
quential damages, so these limitations or exclusions may not apply to you. This warranty gives you specific legal rights and
you may have other rights which vary from state to state.
ECHO
is a registered trademark of Echo, Incorporated and is used under license by Root-Lowell Manufacturing Company.
®
LIMITED WARRANTY
Root-Lowell Manufacturing Co. • 1000 Foreman Rd. • Lowell, MI 49331
