Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3.5. Energy Saving Advice
Do not install the appliance Glose to sourcesof heat, such as a cooker,
dishwasher or radiator.
Locate the appliance in a cool well-ventilated room and make sure that the air
vents are clear
Try to avoid keeping the doors open for a long time, warm air will enter the
cabinet and may cause a build-up of ice as well as affecting the energy
consumption. Ensure there are no obstructions preventing the doors from closing
properly
Ensure that the door seals are clean and there are no tears or splits.
Keep the most perishable foods, <those with a shortshelf-life, such as
cooked meatsl, in the coldest part of the fridge. The Salad Crispar Box is
the warmest part of your fridge and should be used for vegetables, salads and
fruits etc. <see Description of Appliance on Page 3)
Do not overload the fridge: the cooling air that circulates to keep the
fridge cold gets blocked and pockets of warm air form.
Do not put hot food into the fridge or freezer. let it cool down first.
3.6. In the Event of a Power Failure
lf there is a power failure, keep the doors closed. When the power has been restored
the appliance will start to operate but it may take sorne time to achieve the pre-set
operating temperatura. Check the condition of your stored food items and liquids.
3.7. Climate Range
The information about the climate range of the appliance is provided on the rated plate .
lt indicates at which ambient temperatura (that is, room temperatura, in which the appliance
is working) the operation of the appliance is optimal (proper)
Climate range
SN
N
ST
T
Permissible ambient temperatura
from +1 O
º
C to +32
º
C
º
º
from +16
C to +32
C
from +16
º
C to +38
º
C
º
º
from +16
C to +43
C
8
V.1
Section 1. 1 nstallation
IMPORTANT! This appliance must be left to stand in an upright positiorfor at
least 4 hours before being switched on for the first time.
This appliance has been designad for Domestic Use Only.
Remove all packaging and securing tape from the appliance.
Wash the interior of the appliance with luke warm water containing a small
amount of bicarbonate soda <5ml to 0.5 litres of water>.
Position the appliance in a dry atmosphere and out of direct sunlight .
Do not position next to a cooker or other sources of heat, i.e. radiator.
This appliance should not be sited in a cold atmosphere, i.e. garage or
shed. Doing so may cause the freezer unit to underfreeze.
lf positioned next to another fridge or freezer, leave a minimum gap of 2cm
between the appliances in order to avoid condensation.
A clearance of 50mm should be left above the appliance. lf this cannot be
achieved you should ensure a clearance of 25mm is maintained on each side of
the appliance.
Fit the plastic wall spacers to the condenser on the rear of the appliance, this will
ensure an air gap between the appliance and the wall.
Do not place or store heavy items on the top of this appliance.
Ensure that the appliance is positioned on a firm flat floor.
This appliance must be level. Adjust the level by screwing the adjustable feet up
or down <use your fingers or a suitable spanner).
Ensure that the appliance is upright and both feet are in firm contact with the floor
so that the cabinet is stable.
Connect the plug to an adjacent 13amp socket out let and ensure that the
appliance is not standing on the supply cable.
o
o
Suggest:lt is advisable for there to be at least 75mm of space from the back to the wall,
at last 100mm from its top, at last 100mm from its side to the wall and a clear space in
º
front to allow the doors to open 130
300
300
905
. As shown in above diagrams .
5
V.1
Tabla de contenido
