Tips For Saving Energy - EAS ELECTRIC EMF144E Manual De Instrucciones

Recommendations
 If the appliance is switched off or
unplugged, wait at least 5 minutes
before plugging the appliance in or
restarting it in order to prevent
damage to the compressor.
 If you will not use your appliance for
a long time (e.g. in summer holi-
days) unplug it. Clean your applian-
ce according to chapter cleaning
and leave the door open to prevent
humidity and smell.
 If a problem persists after you have
followed all the above instructions,
please consult the nearest authori-
sed service centre.
 The appliance you have purchased
is designed for domestic use only. It
is not suitable for commercial or
common use. If the consumer uses
the appliance in a way that does not
comply with this, we emphasise that
the manufacturer and the dealer
will not be responsible for any repair
and failure within the guarantee
period.

8 TIPS FOR SAVING ENERGY

1. Install the appliance in a cool, well-
ventilated room, but not in direct
sunlight and not near a heat source
(such as a radiator or oven) other-
wise an insulating plate should be
used.
2. Allow warm food and drinks to cool
before placing them inside the
appliance.
3. Place thawing food in the refrigera-
tor compartment if available. The
low temperature of the frozen food
will help cool the refrigerator com-
partment while the food is thawing.
This will save energy. Frozen food
left to thaw outside of the applian-
ce will result in a waste of energy.
4. Drinks or other liquids should be
covered when inside the appliance.
If left uncovered, the humidity
inside the appliance will increase,
therefore the appliance uses more
energy. Keeping drinks and other
liquids covered helps preserve their
smell and taste.
5. Avoid keeping the doors open for
long periods and opening the doors
too frequently as warm air will
enter the appliance and cause the
compressor to switch on unnece-
ssarily often.
6. Keep the covers of the different
temperature compartments (such
as the crisper and chiller if avai-
lable) closed.
7. The door gasket must be clean and
pliable. In case of wear, replace the
gasket.
EN - 68 V.2