Lucimed Glasses 3 Modo De Empleo página 14

EN
•
Plug the charger into the mains.
•
When the device is completely charged (the charge time is 2 hours), unplug
the charger.
You can also charge your Luminette® by connecting it to your computer using the
USB cable supplied.
Charge indicator:
•
When your Luminette® is charging, the 3 battery indicators will continually
flash slowly in a cycle.
•
When your Luminette® is fully charged, these 3 battery indicators stop
flashing and remain lit.
•
If there is an error (battery or circuit failure), one of the indicators flashes
rapidly without interruption.
The device may not be used when it is charging.
Battery life:
The battery life will depend on the intensity you choose. A correctly charged
Luminette® device should lit for at least 10 sessions.
When you turn the device off, between 1 and 3 battery indicators light up to give
you an indication of the remaining battery life (3 indicators = the battery is fully
charged; 2 indicators = the battery is 2/3 charged; 1 indicator = the battery is 1/3
charged; 1 flashing indicator = the battery is insufficiently charged to be able to
complete a session).
We recommend recharging your Luminette® when there is only one indicator
remaining when you turn the device off.
F. Switching on and off
Attention: before your first use, be sure you take off the protective film over the
hologram.
Ensure that the battery is charged so that your Luminette® will work for the entire
session chosen. Press the Start-Stop button briefly to turn your Luminette® on
(see figure 1).
To change the intensity of the light, just press the Start-Stop button briefly. The
intensity will change in a cycle: level 1, then level 2, level 3, and back to level 1, etc.
14