Troubleshooting - Worx WG602 Manual Del Usuario

MAINTENANCE
Remove plug from the socket before carrying out any adjustment, servicing or maintenance.
Inspect the product for damaged or worn parts before each use. Do not operate it if you find damaged or worn parts. Contact
your supplier or the manufacturer for replacement parts.
Power cord maintenance
If the electrical cord is damaged, do not attempt to repair yourself; call the Worx solutions center for further assistance.
Pump maintenance
Inspect the pump frequently whether any leaking occurs around the pump seal. If leaking occurs, contact the solutions center
for further assistance.
Nozzle maintenance
Remove the nozzle from the lance, then remove any possible obstructions using the included declogging needle (See Fig.
L).Then use a garden hose to rinse the nozzle by backwashing
WARNING: Any other servicing should be performed by an authorized service representative.
STORAGE
1. Disconnect the water source. Turn on the pressure washer for a few seconds until the remaining water flows out. Then turn
it off quickly.
2. Unplug the power supply .Wind power cord on the tool and use power cord clip to fix . (See Fig.J1)
3. Disconnect the high pressure hose and the garden hose (not supplied), and coil high-pressure hose for storage. Insert the
Wand and lance separately into the Wand Holder and lance holder. (See Fig.M)
4. Store in a frost free area with a temperature above 0°C(32°F).

TROUBLESHOOTING

Symptom
Machine does not start
when the switch is in"
I"position.
Machine pressure is
not consistent.
The pressure of the
pump is not adequate
Lance leaks
Electric Pressure Washer
Possible causes
Power cord is not plugged in.
.
Socket is defective
GFCI is triggered.
Pump is faulty.
Air in line.
Water inlet adapter is clogged
or dirty.
Water supply is Insufficient.
Water supply is restricted.
Diameter of garden hose is too
small.
Leak or kick in hose .
O-ring needs to be replaced (See
Fig. A1) . .
Solution
Plug in power cord.
Check or replace plug, socket, fuses.
Press reset on GFCI plug.
Contact service center .
Remove the nozzle, turn on the machine for a while and
install the nozzle back.
Remove the adapter, rinse it with water and put is back.
Open water source completely.
Check If the water hose kinks or leaks.
Replace with right garden hose .
Replace hose or untie kinks in hose.
Replace o-ring .If the problem is not solved ,contact service
center to buy a new lance.
11
EN