Safety Thermostat - Valentine TF5/55 Manual De Instrucciones

All Valentine fryers are fitted with a safety thermostat for each tank. These safety thermostats
are placed in the heating element box at the back of the fryer. The red reset button [15] goes
up underneath the housing.
It is triggered:

when the oil temperature exceeds 230°C

when the capillary tube is damaged

when the temperature falls below 0°C
or when the appliance is not being used properly:

when it is being heated without oil or the oil level is too low

when it is being drained without triggering the switch

when a block of fat is being melted directly on the heating element
To reset the fryer:
 Stop the fryer
 Allow the fryer to cool down
place it on the lid). Until the thermostat bulb [13] attached to the heating element cooled
down, you cannot reset the safety thermostat
 Press down firmly on the red button
Problem
The fryer is not heating.
The fryer is not heating suffi-
ciently
The control lamp does not light
up or flashes
The control lamps light up but
the fryer does not heat up
Other fault

Safety thermostat

(thermostat switch [1] to Pos. "0")
Problems and faults
Probable cause

No power

Safety thermostat has been
triggered

Housing not properly in place

One phase is missing

Heating element is faulty

Faulty control lamp

One phase is missing

Heating element is faulty or the
thermostat is faulty
(to speed this process up lift the heating element and
[15] (until you hear the "click")
Action

Carefully check the fuses, plug
and socket

Reset it (see above)

Check that the housing is in the
correct position

Check the fuses

Call the after-sales service team

Change the control lamp

Check the fuses

Call the after-sales service team

Call the after-sales service team
25