Taurus ITALICA PREMIUM Manual Del Usuario página 6

English
Italica premium
Dear customer,
Many thanks for choosing to purchase a TAURUS brand product.
Thanks to its technology, design and operation and the fact that it exceeds the
strictest quality standards, a fully satisfactory use and long product life can be
assured.
Description
A Lower body.
B Funnel - Filter.
C Upper body.
D Safety valve.
Safety advice and warnings
- Read these instructions carefully
before switching on the appliance and
keep them for future reference. Failure
to follow and observe these instructions
may result in an accident.
-Do not permit chidren to go near the
coffee maker when it is in use
-Do not operate the opening / closing
system before the coffee maker cools
and after emoving it from the heat
source
- Ensure that the coffee maker is pro-
perly closed before using it
- This appliance is for domestic use
only, not for industrial use.
- Do not leave the appliance within the
reach of children or disabled people.
- No responsibility is accepted for da-
mage caused by improper handling,
or by use other than that designated
in this manual.
- Periodically check the condition of the
accessories (rubber seal, filter, etc.) and
replace them when they show signs of
deterioration.
- Do not use the coffee maker without
water in the distiller.
- Do not use this appliance for purposes
other than those designated.
Manual Italicas.indb 6
- Do not touch the hot surfaces.Use the
handle and the puller.
- Use only the replacement parts
supplied by the manufacturer and its
authorised support services
- Ensure that the jet of steam which
can exit through the safety valve is not
directed near the user.
Instructions for Use
Before using it, clean the internal part of the coffee maker well with water and
detergent.
Unscrew the upper body (C) from the lower body (A).
Fill the lower body (A) with water to the valve (D).
Put the ground coffe into the funnle (B) and place it in its housing.
Firmly screw the two bodies together.
Place the coffee maker on a heat source (gas, vitroceramic, electric or
induction).
Remove the coffee maker from theheat source when the coffee has exited
completely.
Cleaning
- Clean the equipment with a damp cloth with a few drops of washing-up liquid
and then dry.
-Do not use solvents or abrasive products to clean it.
Anomalies and repair
If there occurs any anomaly, do not attempt to repair it. Contact an authorised
service centre.
03/09/14 17:23