Makita 9227C Manual De Instrucciones página 6

1 2
003448
Always install the loop handle on the tool before
operation. Hold the tool's switch handle and the loop
handle firmly with both hands during operation.
Install the loop handle so that its protrusion will fit into
the matching hole in the gear housing.
Install the bolts and tighten them with the hex wrench.
The loop handle can be installed in two different
directions as shown in the figures whichever is
convenient for your work.
1
2
003449
1 1
2
003450
Installing side grip (handle)
(optional accessory)
CAUTION:
Always be sure that the side grip is installed
•
securely before operation.
Screw the side grip securely on the position of the tool
as shown in the figure.
1. Protrusion of
loop handle
2. Matching hole
in gear housing
1. Loop handle
2. Hex wrench
3. Bolt
3
1. Loop handle
3 2. Bolt
3. Hex wrench
003805
Installing or removing the wool bonnet
(optional accessory)
1
2
3
003467
To install the wool bonnet, first remove all dirt or foreign
matter from the backing pad. Press the shaft lock and
screw the backing pad onto the spindle. Insert the
sleeve 18 into the center hole of the backing pad.
Using the sleeve 18 as a positioning guide, install the
wool bonnet on the backing pad with the sleeve 18
inserted through the center hole of the wool bonnet.
Then remove the sleeve 18 from the backing pad.
To remove the wool bonnet, just tear it off the backing
pad. Then unscrew the backing pad while pressing the
shaft lock.
Installing or removing abrasive disc
(optional accessory)
1
2
3
003457
NOTE:
Use sander accessories specified in this manual.
•
These must be purchased separately.
Mount the rubber pad onto the spindle. Fit the abrasive
disc on the rubber pad and screw the lock nut onto the
spindle.
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
6
1. Wool bonnet
2. Sleeve 18
3. Backing pad
4. Spindle
5. Shaft lock
4
5
1. Lock nut
2. Abrasive disc
3. Rubber pad
4. Spindle
4