Tabla de contenido
Idiomas disponibles
Idiomas disponibles
7.
Install the new harness from the service kit and connect it to
the panel mount connector.
8.
Install the U-shaped clip on the buzzer. Note orientation of
the U-shaped clip on the buzzer. See Figure 5.
U-SHAPeD ClIP
IMPORTANT: Ensure that the orientation clip is already installed.
9.
Mount the buzzer behind the glider rail using the screw
removed in step 3, by putting the screw through the hole
below the orientation clip. The buzzer wires should be facing
downward. See Figure 7.
ORIeNTATION ClIP
SCReW
10. Make the connections to the compressor, fan (when appli-
cable) and the water valves (when applicable).
11. Mount the machine compartment cover.
CONTROl BOx ASSeMBly INSTAllATION
12. Open the door; you will need a Phillips screw driver.
13. Remove the two screws on either side of the control box.
14. Disconnect the two connectors in the box.
15. Remove the light lens and light bulb.
© Whirlpool Corporation 2014
(All Rights Reserved)
BUzzeR WITH U-SHAPeD
ClIP INSTAlleD
figure 5
BUzzeR
WIReS
figure 6
16. Disconnect the taco clip that grounds the heat shield.
See Figure 7.
17. Replace with the new Electronic Control, connect the two
connectors and install taco clip on heat shield.
IMPORTANT: Make sure that the taco clip is installed on the
heat shield.
18. Mount the control box with the two Phillips screws re-
moved in step 13, and replace the light bulb and light lens.
19. Replace all parts and panels.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
20. Plug in refrigerator or reconnect power.
— 2 —
CONTROl BOx ASSeMBly
figure 7
WARNING
TACO ClIP
CONNeCTOR
W10812019 B
Tabla de contenido
