Whirlpool WSR57R18DM Hoja De Instrucciones

Kit Contains:
1 Wire Harness
1 Orientation Clip
1 U-shaped Clip
1 Electronic Control
1 Instruction Sheet
WARNING
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death
or electrical shock.
1. Unplug refrigerator or disconnect power.
2. Using a ¼" nut driver remove the screws from the machine
compartment cover. See Figure 1.
3. Using a ¼" nut driver remove the screw from the piezo buzzer.
See Figure 2.
Instruction Sheet W10812019 Rev. B 8/24
Instruction Sheet
For Piezo Buzzer and Electronic Control Kit
Electrical Shock Hazard
figure 1
figure 2
Tools Needed:
4. Disconnect the harness from the compressor, fan (when
applicable) and the water valves (when applicable) from the
product.
5. Disconnect the harness from the panel mount connector and
discard harness. See Figure 3.
IMPORTANT: Make sure that the orientation clip is installed prior
to mounting the piezo buzzer.
6. Install the orientation clip on the glider rail, in between the
top two holes above the power cord. Note orientation of the
orientation clip on the glider rail. See Figure 4.
TOP 2 HOleS
ABOve POWeR
CORD
— 1 —
¼" Nut Driver
Phillips Screwdriver
Wire Cutter
Inspection Mirror
figure 3
ORIeNTATION ClIP
ClIP INSTAllATION
lOCATION
figure 4
(continued)