Installing The Refrigerator - Cafe CWE23SP2MS1 Manual Del Propietario E Instrucciones De Instalación

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Installation Instructions

INSTALLING THE REFRIGERATOR

REFRIGERATOR LOCATION
Do not install the refrigerator where the
temperature will go below 60°F (16°C) because
it will not run often enough to maintain proper
temperatures.
Do not install the refrigerator where the
temperature will go above 100°F (37°C) because
it will not perform properly.
Do not install the refrigerator in a location exposed
to water (rain, etc.) or direct sunlight.
Install it on a floor strong enough to support it fully
loaded.
CLEARANCES
Allow the following clearances for ease of
installation, proper air circulation and plumbing and
electrical connections.
REMOVING THE REFRIGERATOR
DOORS
IMPORTANT NOTE: This refrigerator is 36
(31
/
1
4
leading to the installation location must be at least
36
/
1
4
attached to the refrigerator while transporting it into
the installation location. If passageways are less
than 36
/
1
4
easily be scratched and damaged. The top cap and
doors can be removed to allow the refrigerator to be
safely moved indoors. If passageways are less than
31
/
1
4
If it is not necessary to remove doors, skip to Step
11. Leave tape and all packaging on doors until the
refrigerator is in the final location.
NOTE:
refrigerator. Place the refrigerator on the hand
truck with a side against the truck. We strongly
recommend that TWO PEOPLE move and complete
this installation.
49-60820-1
REMOVE THE FRESH FOOD
1
DOOR HANDLE
Handle Design varies based on models, however
Installation is same.
Stainless steel and plastic handles:
wrench and remove the handle.
NOTE: If the handle mounting fasteners need
to be tightened or removed, use a 1/4 Allen
wrench.
Mounting
Fasteners
REMOVE THE FREEZER DOOR
2
HANDLE
/
1
4
Handle Design varies based on models, however
Installation is same.
Stainless steel and plastic handles:
wrench and remove the handle.
NOTE: If the handle mounting fasteners need to
be tightened or removed, use a 1/4 Allen wrench.
Mounting
Fasteners
Leave film
on until after
installation
Reinstall the handles using the same procedure as
removing.
Leave film
on until after
installation
25
Tabla de contenido
loading

Este manual también es adecuado para:

Cfe28tp2ms1Cfe28up2ms1

Tabla de contenido