Installation Steps; Care And Cleaning - LUND Interceptor Instrucciones De Instalación

Installation Steps

Remove hood shield from hood.
3
Remove screw. Center hood shield and attach
using (4) screws and (4) washers.
3/4" (1.9 cm)
washer
screw
5
NOTE: The hood shield should be offset approxi-
mately 3/4" (1.9 cm) from the front edge of hood.
Lower hood, adjust hood bumper stops if necessary. Clean hood surface at locations shown with
7

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Lund
and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in terms of
fit, durability, finish and ease of installation.
™
NOTE: Actual application may vary slightly from drawings.
alcohol pads. Apply bump-ons to hood surface.
®
branded products offered by Lund International, Inc. We take the utmost pride in our products
Lund International
800-241-7219 • Visit us at lundinternational.com
© 2014 Lund International, Inc. All rights reserved.
Lund and the Lund logo are trademarks of Lund International, Inc.
® ®
Drill a pilot hole at locations marked in Step 2
using a drill with a #2 Phillips bit and using one
of the supplied self tapping screws.
4
Hood Hood shield Washer
6
Page 2 of 2
NOTE: Use caution not to drill
completely through hood!
Do No Overtigthen
Bump On