Uline H-214 Manual Del Usuario página 2

Rear Brace
Figure 3
Figure 4
Spacer
Spacer
Figure 5
PAGE 2 OF 12
ASSEMBLY CONTINUED
Small Dowel
Large Dowel
Upright
LEG ASSEMBLY CONTINUED
4. Next, attach the rear brace extending from the
back of one leg to the other using 1/4 - 20 x 2" hex
bolts. Secure with washer and nut. (See Figure 3)
5. Turn table over to the upright position.
6. Place large dowel into dowel sockets in the middle
of the table legs. (See Figure 4)
SHELF ASSEMBLY
1. Attach the right and left shelf uprights by first
removing the 4" bolts from back leg assemblies.
Add spacers in between the leg assemblies and
shelf uprights, and finally re-insert bolts through the
uprights, spacers and leg assemblies. (See Figure 5)
The shelving can be positioned at one of the three
heights by utilizing the first and third, second and
fourth, or third and fifth drilled holes on the shelf
upright.
NOTE: DO NOT tighten the hardware.
NOTE: The nylon bushings on the shelf uprights
should be facing inward towards the table.
2. Insert ends of the second small dowel into the nylon
bushings on the shelf uprights. Bushings and dowel
can be positioned in any of 3 height positions
depending on your application. Tighten the
hardware for the uprights.
0521 IH-214