Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Electrical
Risk of electric shock. Can shock, burn or kill. When installing, operating, or servicing this pump, follow safety
instructions listed below.
1.
DO NOT splice the electrical power cord.
2.
DO NOT allow the electrical cord plug to be submerged.
3.
DO NOT use extension cords. They are a fire hazard and can reduce voltage sufficiently to prevent pumping
and/or damage the motor.
4.
DO NOT handle or service the pump while it is connected to a power supply.
5.
DO NOT remove the grounding prong from the plug or modify the plug to protect against electrical shock. The
power cord is a three-wire conductor and includes a 3-prong grounded plug. Plug the pump into a 3-wire,
grounded, grounding type receptacle. Connect the pump according to electrical codes that apply.
For automatic operation, plug or wire the pump into an automatic float switch or pump controller. The pump will run
continuously when plugged directly into an electrical outlet. Connect or wire the pump to an individual branch circuit
with no other outlets or equipment in the circuit.
Size fuses or circuit breakers according to this chart:
Fuse Data
HP
Voltage
3/4
115
1/2
115
OPERATION
Do not handle this pump or plug in or unplug this pump with wet hands or while standing in water, unless you are certain all power
has been turned off to the pump. Remember, the pump should be connected only to a properly grounded, GFCI outlet.
1.
Make certain the pump is submerged in water. Running the pump dry can damage the shaft seal.
2.
Plug the pump cord into the back of the float switch cord's plug. Plug the float switch cord into a 115V GFCI
power outlet.
3.
After connecting power to the pump and periodically afterwards, test the pump:
a. Fill the basin to above the float switch operation on height. The pump should start pumping.
b. The pump should pump the water down to below its Float Switch Operation OFF Height and then stop pumping.
c. If the water drains back into the basin and restarts the pump, make sure the check valve is properly installed and
working. Also make sure that all pipe connections are tight.
4.
The motor is equipped with an automatically resetting thermal overload protector. If the motor gets too hot, the
overload protector will shut off the pump before it is damaged. When the motor has cooled sufficiently, the
overload protector will reset, and the motor will restart.
If the overload protector stops the pump repeatedly, disconnect the power from the pump and check to find the problem. Low
voltage, a long extension cord, clogged impeller, screen blocked by debris, or water that is too hot can cause motor overheating.
6
Individual Branch Circuit Required (Amps)
15
15
For Professional Technical Support call 1-844-242-2475
Tabla de contenido
Solución de problemas
