Tabla de contenido
Idiomas disponibles
Idiomas disponibles
WARNING: This product maybe
contains lead, phthalate or other
chemicals known to the State of California
to cause cancer, birth defects and other
reproductive harm. Please wash your hands
after use.
INFORMATION FOR RADIATED
EMISSION
This device complies with Canadian ICES-001.
This device complies with Part 15 of the FCC
Rules.
Operation is subject to the following two
conditions:
1) This device may not cause harmful
interference, and
2) This device must accept any interference
received, including interference that may
cause undesired operation.
WARNING: Changes or modifications
to this unit not expressly approved by
the party responsible for compliance could
void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the
equipment and receiver.
•
Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/
TV technician for help.
Battery Charger
CHARGING PROCEDURE
NOTE: Before using the tool, read the
instruction book carefully.
1. CHARGING YOUR BATTERY PACK
WARNING: The charger and battery
pack are specifically designed to work
together so do not attempt to use any other
devices.
The Li-Ion battery is protected against deep
discharging. When the battery is empty,
the machine is switched off by means of a
protective circuit.
WARNING: When battery charge runs
out after continuous use or exposure to
direct sunlight or heat, allow time for the tool
to cool down before re-charging to achieve the
full charge.
2. BEFORE USING YOUR CORDLESS TOOL
Your battery pack is UNCHARGED and you
must charge once before use. When you
charge the new battery or one which has not
been used for long periods of time, it may
not reach full charge until after you have
discharged it fully in use and recharge it
several times.
3. HOW TO CHARGE YOUR BATTERY
PACK (See Fig. A, B)
Connect the battery charger to the power
supply. Then, push battery into charger base
(2)until you hear a sound "click" , connection
is finished and the light (1) will turn green
flashing to show charging has started, until the
battery is fully charged. A discharged battery
at normal ambient temperature will take
approximately 5 hours to reach full charge.
When charging is completed, unplug the
charger and remove the battery pack.
NOTE: This charger is designed to detect
some problems that can arise with battery
pack. (see table below)
5
EN
Tabla de contenido
