Panasonic WV-CW7S Instrucciones De Operación página 3

Step 3
Replace the dome cover
AAttach the waterproof rubber provided with
the new dome cover to the enclosure. Make
sure that the waterproof rubber is attached
without distortion or deformation. Do not
use the waterproof rubber removed from the
enclosure. Use the new waterproof rubber
provided with the new dome cover.
BRemove the protection film covering outside
the new dome cover.
Keep the removed protection film until using
it upon the installation.
(Handle the new dome cover with care not
to scratch inside and outside.)
CFit the new dome cover, the light-blocking
sheet (WV-SFV631LT/ WV-SFV631L/
WV-SFV611L only) and the dome cover hol-
ding plate together while aligning the holes
on them to the 2 protrusions inside the
enclosure, and then fix them using the 2
dome cover fixing screws (without washers).
(Recommended tightening torque:
0.78 N·m {0.58 lbf·ft})
DAttach the protection film removed in
step 3 - B back to the outside the dome
cover.
EWhen fixing the third dome cover fixing
screw (with washer), fix the installation auxi-
liary wire together.
When fixing with the screw, make sure that
the flat face of the fixing terminal is the sur-
face side of the dome cover holding plate.
Make also sure that the fixing terminal is not
on the projection of the dome cover holding
plate. (Refer to the diagram below.)
(Recommended tightening torque:
0.78 N·m {0.58 lbf·ft})
Step 4
Fit the enclosure back to the camera body
Fix the enclosure onto the camera body using
the 4 enclosure fixing screws.
The recommended tightening torque for the
enclosure fixing screws is 0.78 N·m {0.58 lbf·ft}.
⇒
Refer to the Installation Guide of the camera
for the subsequent procedures including the
installation of the camera body.
IMPORTANT:
• Defocus may be caused by the reinstalled
enclosure. After installing the enclosure,
activate the auto focus function from the
setup menu.
• Remove the protection film covering the
outside of the dome cover after completing
the installation.
• Wipe out with a soft cloth when cleaning
adhesion of dirt such as a fingerprint.
(WV-CW7S only)
• Refer to "Precautions"(leaflet) and clean
the dome cover. (WV-CW7SN only)
3