Parts List - BGS technic BGS 8717 Manual De Instrucciones

OPERATE
1. Place the sand blast cabinet near a 230V/60Hz AC electrical outlet. Make sure the receptacle will
accept the 3 -prong plug so that the unit will be properly grounded. Also make sure to check the
power source is adequate for use with this blast system.
2. Attach the air supply line from a compressor capable of maintaining 142 l/min at 5.6 bar to the
inlet connector found on the right side of the cabinet. Because of variation in air supply systems,
the air inlet coupling is not provided. Use the particular fitting that is compatible with your air
supply system. Do not operate the blasting system at over 5.6 bar.
3. Check the air supply line fittings and hose attachments to the rear of the gun. Also make sure the
media supply hose is attached lightly on the nipple on the underside of the gun.
4. Place no more than 10 pounds of abrasive media into the center of the cabinet. Excessive
amounts will create clouded cabinet conditions, blow by media through the exhaust or sluggish
and ineffective blasting performance.
5. With the air supply connected, all fittings and joints not leaking and the unit is plugged in. You are
ready to test the blasting system. Now follow these steps for start up operation.
6. Place the part in the cabinet. Always close and latch the lid after placing the part in the cabinet
prior to blasting. Severe injury to the skin and eyes may result from exposure to the blast stream.
After pulling your hands into the gloves grasp the gun and depress the trigger. This should begin
the blasting flow. If no flow is seen you may need to clear the tube by covering the gun nozzle
momentarily.
7. Now you may begin finishing the part. You should move the blast stream continuously over the
part in an even and circular motion. The flow should not be too hard or concentrated to avoid
undesirable peening.

PARTS LIST

1 Transparent Top Lid
1-1 Top Lid Position Chain
1-2 Screw
1-3 Nut
1-4 Movable Leaf
1-5 Plastic Screw
2 Front Panel
3 Rear Panel
4R Right Panel
4L Left Panel
5 Base
6 Lamp Clamp
7A LF RR Leg
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
7B RF LR Leg
8 Screw 1/4x3/8"
9 Screw 5/32x3/8"
9-1 Nut 5/32"
10 Nut
11 Sanding Gun
12 Nozzle
13 Air Supply Hose
14 Plastic Suction Hose
15 Steel Suction Hose
16 Air Hose Connector
17 Washer
18 Air Supply Connector
Tel.: 02196 720480
Fax.: 02196 7204820
[email protected]
19 1/4" Hose Clamp
20 Glove Clamp
21 Glove
22 Self Drilling Screw
23 Screw
24 Air cleaner
24-1 Filter
25 Anchor Plate
26 Lamp
26-1 Feed thru
27 Wire Connector Box
27-1 AC-AC Adaptor
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed