Tabla de contenido
Idiomas disponibles
Idiomas disponibles
15. Parameter inquiry
Press and hold Reset button for 5 seconds, enter into parameter inquiry. Code Fxx would be displayed on time area, xx
is two digital numbers which represents parameter code. The specific value of the parameter would be displayed on the
temperature zone area. Press button the
16. Parameter recovery
Under none set state, press and hold the
displayed on the panel. Press the
please check the factory default parameter in factory parameter settings).
17. Manual compulsive defrost
Press and hold the
higher than the exit defrosting temperature, it will not enter defrosting.
18. Safety lock function
If there is no any operation in 2 minutes, system would automatically lock all the buttons. Then all the buttons are
invalid. Press and hold the
19. Check the water tank bottom water temperature
Press button + and – simultaneously to check it.
Parameter codes are show as below:
You can inquiry or modify it through pressing SET button. You have to input password if you want to modify
it. Parameter F8 is used to save the history fault.
Type
Code
Solar water outlet
F0
temperature display
Display
Ambient temperature
F1
series
display
V.2
5. Operating Instruction
or
button, all the parameters would be recovered to factory default settings. (Note:
buttton for 10 seconds, then system would be forced to defrost. When the coil temperature is
and
buttons at the same time for 3 seconds to release the lock.
5. Operating Instruction
Parameter name
Setting ranges
to select and display the parameter.
and
buttons simultaneously for 1 second, word dEF would be
Default
settings
-
-
-
-
50
Note
Unit
This
item
displayed when the solar
C
dial switch is valid
Password
unnecessary,
C
cannot be revised
will
be
Capítulos
Tabla de contenido
