BLACK&DECKER BEBLV260 Manual De Instrucciones página 10

ENGLISH
Do not expose the tool to rain or
high humidity or leave outdoors
while it is raining.
Switch off: remove plug from
mains before cleaning or mainte-
nance.
Disconnect the mains plug if
the cord becomes damaged or
entangled.
Beware of flying objects.
Keep bystanders away.
Directive 2000/14/EC guaran-
teed sound power.
Features
This appliance includes some or all of the following features.
1. On/Off switch - speed control
2. Front handle
3. Back handle
4. Power head
5. Upper vacuum tube
6. Lower vacuum tube
7. Upper blower tube
8. Lower blower tube
9. Collection bag
10. Fan guard
Using your product
Warning! When using as a blower or vacuum, always wear
safety glasses. If using in dusty conditions, wear a filter mask
as well.
Warning! Switch off your product, allow the fan to stop and
remove the plug from the socket before carrying out any
adjustment, servicing or maintenance.
Assembly
Warning! Before assembly, make sure that the
appliance is switched off and unplugged.
Warning! Always wear protective gloves when
working with your blow vac.
Vacuum tube assembly (fig. A)
The vacuum tubes must be assembled together before use.
10
(Original instructions)
Warning! Do not operate the appliance with the vacuum
tubes separated.
To ease assembly, apply a soapy water solution to the
u
joint area.
Align the notches (5a) and the recesses (6a) on the upper
u
(5) and lower (6) vacuum tubes.
Push the lower vacuum tube (6) firmly onto the upper
u
vacuum tube (5) until they click into place.
Warning! Do not separate the tubes once assembled.
Vacuum mode (fig. B, C, D, E, F, G, H, I, J, K, L, M)
Rotate the fan guard assembly anti-clockwise as shown in
u
figure B.
Insert the rod (12) (supplied) into the fan guard release
u
(11) and push upward to release the fan guard assembly
(10) as shown in figure C.
Drop the fan guard assembly (10) forward as shown in
u
figure D.
Insert the assembled vacuum tube (5) into the available
u
recess in the power head (4) as shown in figure E.
Insert the collection bag (9) onto the power head (4) as
u
shown in figure E.
Rotate the assembled vacuum tube clockwise so that the
u
bayonet fixing locks into place as shown in figure F.
Place the straps from the collection bag over your
u
shoulder (fig. G) this will support the additional weight as
the back pack collection bag fills.
Position the vacuum tube slightly above the debris/leaves.
u
Switch on the appliance by pushing the On/Off switch (1)
upwards (fig.G insert) and use a sweeping motion; the
debris/leaves will be sucked up the tube, and thrown into
the collection bag (9) (fig. G).
To empty the collection bag (9) unzip the rear end and
u
proceed to empty its contents as shown in figure H.
When task is complete, rotate the assembled vacuum
u
tube anticlockwise to release the bayonet fixing. Insert the
rod (12) into the fan guard release (11) and push upwards
to release the assembled vacuum tube. Remove the
assembled vacuum tube from the powerhead as shown in
figure J.
Replace the fan guard assembly as shown in figure K.
u
Rotate the fan guard assembly clockwise as shown in
u
figure L.
Blower mode (fig. M, N, O, P)
Assemble upper blow tube (7) with lower blow tube (8) as
u
shown in figure M.
Push the assembled blow tube onto the vacuum outlet
u
(13) until the lock engages tightly with the blow tube
(fig.N).
Warning! Never operate in Blow mode without the blow tube
firmly in place.