Putting Into Operation; Working Instructions; Maintenance And Service - Bosch 0 607 161 1 Serie Manual De Instrucciones

Putting into Operation

The air tool operates optimally with a pressure of
6.3 bar (91 psi) measured at the air inlet with the tool
running.
Remove adjusting keys before turning the tool
on. A key that is left attached to a rotating part of the
tool may result in personal injury.
Switching On/Off
If the tool does not run – for example, after not being
used for a prolonged time – disconnect the air supply
and turn the motor repeatedly using a suitable open
end wrench 26 on the wrench flats 11 (see Fig.
This eliminates adhesive forces.
Type 0 607 161 100 – ... 103
Switching on: Press the lever 27.
Switching off: Release the lever 27.
Type 0 607 161 500 – ... 507
Switching on: Press the on/off switch 9.
Switching off: Release the on/off switch 9. The on/off
switch 9 of drills with a pistol grip is
constructed with two components. To
switch on/off, either the top or the bot-
tom of the switch may be pressed.
Maintenance
Disconnect the air hose from the air supply before
making any adjustments, changing accessories,
or storing the tool. Such preventive safety measures
reduce the risk of starting the tool accidentally.
Should the tool fail in spite of careful manufacturing and
testing procedures, have the repairs performed by an
authorized customer service location for Bosch power
tools.
For inquiries and spare parts ordering, please include
the 10-digit order number on the nameplate of the tool.
Clean the screen of the air inlet regularly. For this pur-
pose, unscrew the hose nipple 4 and remove dust and
dirt particles from the screen. Then firmly remount the
hose nipple (Type 0 607 161 1.. see Fig.
0 607 161 5.. see Fig.
To prevent damage to the internal valve components
of the tool, you should use an open end wrench
(22 mm) to apply a counterforce at the protruding con-
nector of the air inlet 3 when screwing/unscrewing the
hose nipple 4.
3 609 929 935 • (03.10) T

6 MAINTENANCE AND SERVICE

).
C

Working Instructions

Disconnect the air hose from the air supply before
making any adjustments, changing accessories,
or storing the tool. Such preventive safety measures
reduce the risk of starting the tool accidentally.
Excess loads that cause the tool to stall or reduce
speed will not damage the motor.
In the event of an interruption of the air supply
or reduced operating pressure, switch off the
tool. Check the operating pressure and start
again when the pressure returns to normal.
).
E
let the tool run for 5–10 s while catching the oil that
runs out with a rag. If the air tool is not used for a
longer time, this procedure should always be
performed.
For all Bosch pneumatic tools that do not belong to
the CLEAN series, you should admix an oil mist to the
flow of compressed air. The compressed air oiler re-
quired for this is located on the compressed air main-
tenance unit connected to the tool.
You should use SAE 10 or SAE 20 motor oil for direct
lubrication of the tool or for admixture at the mainte-
, Type
A
nance unit [compressor].
After approx. 150 hours of operation, the gearbox is to
be cleaned for the first time and then after every 300
hours of operation. After each cleaning, it should be
lubricated with special gearbox grease.
Special gearbox grease 225 ml . . . . . 3 605 430 009
English–8
Water and dirt particles in the com-
pressed air cause rust formation and
lead to clogging of vanes, valves, etc.
To prevent this, a few drops of motor oil
should be placed in the air inlet 3. Re-
connect the tool to the air supply and