Function Logics And Settings; How To Secure The Board - Genius LYNX 03 Instrucciones Para El Uso

Maximum force, minimum sensitivity
Minimum force, maximum sensitivity
ON
OFF
Deceleration on opening limit-switch
ON, from limit-switch forward
OFF, immediate stop at limit-switch
Not accepting START on opening and pause
OFF
START command operation
Opens – stop – closes – stop – opens -............
Opens – closes – opens – closes -...........
3 seconds
1.5 seconds
Courtesy light selection / light
Courtesy light goes off after 90 sec
Light ON during opening, pause and closing
Limit-switch selection
Both limit-switches installed
No limit-switch or opening limit-switch only
The outdoor enclosure is designed to house the control unit, the toroidal transformer
and any buffer batteries (Optional).
To secure the toroidal transformer and the board support, consult the specific instruc-
tions.
To secure the control board, follow the instructions below:
1. Position the supplied spacers (Fig. 03 ref.a) on the columns identified by the following
letters: B-C-I-M-Q-F.
2. Secure the board using the supplied screws (Fig. 03 ref. b).
The spacers positioned next to letters C & I serve only for supporting the board.
3. Wire up according to the connection lay-out (paragraph 13).
4. To position and wire the battery kit, refer to the relevant instructions.
If you are using the battery kit, you MUST clear the pre-perforated hole in the lower
part of the enclosure (Fig. 04 ref. a) as requested by current safety laws.

10. FUNCTION LOGICS AND SETTINGS

Function
Electronic clutch
Automatic closing
Condo operation
Deceleration time

11. HOW TO SECURE THE BOARD

SW1 SW2 SW3 SW4 SW5 SW6 SW7 SW8
ON
OFF
ON
OFF
12
Dip-switch
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
1
2
Fig. 03
1
Fig. 04