Installation Steps - LUND Genesis Guia De Inicio Rapido

Installation Steps

Unfold the cover completely and begin to
adjust the rear EZ-Clamps at the rear of the
bed. Again, make sure they are snug but
not tightened completely. (Both front and
rear clamps will be tightened completely in
a later step.)
Tighten
"Counter Clockwise"
Rotate handle lever down from its
storage position. Adjust clamps
to proper height.
Shut the tailgate and make sure the cover is centered on the perimeter of the top of the truck bed. Being sure that
the clamps are just snug, you should be able to gently adjust the cover from the front to rear or side to side as
needed to center the cover over the bed of your truck.
Once you have the cover in the desired position, pull the cover back into the open position in order to firmly
tighten the front clamps. When you pull the cover to the open position, it is important to make sure you secure
your rear clamping handles into the lock position to avoid damage to your cover.
Once you have tightened the front clamps and your Q gaskets are sealed, unfold the cover and make the necessary
adjustments to tighten and secure the rear clamps.
WARNING: Prior to vehicle operation, clamps must be secured so that the clamp's lips
NOTE: Actual application may vary slightly from drawings.
Loosen
"Clockwise"
Slide handle lever to edge of
truck bed rail.
tightly grip the inner bedwall structure.
Page 3 of 4
Rotate handle lever to locking
position. Repeat for opposite
side.