Reverse Function; Circuit Breaker Instructions - ProctorSilex Commercial 78522 Manual De Instrucciones

9. Do not fill the last 3"–4" (7.5–10 cm) of casing. After the entire length of casing
has been stuffed, twist the open end to close and then tie off the ends of the
casing tightly to close. Twist into links.
10. Whenever stuffing sausage, fill the casing slowly to avoid air pockets. If air
pockets do appear in the sausage use a pin to prick the bubbles. The small
holes will seal naturally.
IMPORTANT: Allow the grinder motor to come to a COMPLETE STOP before
engaging in "REV" (or into "Fwd" from the reverse function). NEVER operate the
Grinder in reverse for more than 5 seconds at a time.

REVERSE FUNCTION

•
Allow the Grinder Motor to come to a
COMPLETE STOP before engaging into
reverse "REV" (FIGURE 13).
•
Allow the Grinder Motor to come to a
COMPLETE STOP before engaging in
forward "FWD" after using the reverse
function.
•
NEVER operate the Grinder in reverse for
more than 5 seconds at a time.

CIRCUIT BREAKER INSTRUCTIONS

This Grinder is equipped with a Circuit
Breaker as a safety precaution. If the Grinder
stops running, follow these steps to remedy:
1. Turn the Grinder to the "Off" (O) position.
2. Check the Grinder to see if there is a jam
in the Grinder Head. If there is, the jam
needs to be cleared of the obstruction as
outlined in "Grinding Tips."
3. Press the Circuit Breaker Reset Button
(FIGURE 14).
4. Turn the Grinder back on and resume
grinding.
5. If the Grinder still does not turn on, check that the electrical wall outlet is
properly working. Plug in another appliance to see if that appliance works
from the wall outlet. Check that the household circuit breaker has not been
tripped. If none of the above steps remedy the situation, or if the Circuit
Breaker repeatedly shuts off the Grinder, contact customer service for further
assistance.
NOTICE: DO NOT continue to use the Grinder if the Circuit Breaker trips
repeatedly. Continued use may cause permanent damage to the Grinder and will
void the warranty.
14
FIGURE 13
On/Off/Reverse
Power
Switch
FIGURE 14
Reset
On/Off/Reverse
Button
Power Switch