Safety Instructions - AEG WS 9-100 Manual Original

WARNING!
Read all safety warnings and all instructions, including
those given in the accompanying brochure.
Save all warnings and instructions for future reference.

SAFETY INSTRUCTIONS

Safety Warnings Common for Grinding, Sanding, Wire
Brushing or Abrasive Cutting-Off Operations:
a) This power tool is intended to function as a grinder,
sander, wire brush, or cut-off tool. Read all safety warnings,
instructions, illustrations and specifications provided with
this power tool.
b) Operations such as polishing are not recommended to be
performed with this power tool.
GB
c) Do not use accessories which are not specifically designed
and recommended by the tool manufacturer.
d )The rated speed of the accessory must be at least equal to
the maximum speed marked on the power tool.
e) The outside diameter and the thickness of your accessory
must be within the capacity rating of your power tool.
f) The arbour size of wheels, flanges, backing pads or any
other accessory must properly fit the spindle of the power
tool.
g) Do not use a damaged accessory. Before each use inspect
the accessory such as abrasive wheels for chips and cracks,
backing pad for cracks, tear or excess wear, wire brush for
loose or cracked wires. If power tool or accessory is dropped,
inspect for damage or install an undamaged accessory. After
inspecting and installing an accessory, position yourself and
bystanders away from the plane of the rotating accessory
and run the power tool at maximum noload speed for one
minute.
h) Wear personal protective equipment. Depending on
application, use face shield, safety goggles or safety glasses.
As appropriate, wear dust mask, hearing protectors, gloves
and shop apron capable of stopping small abrasive or
workpiece fragments.
English
14
i) Keep bystanders a safe distance away from work area.
Anyone entering the work area must wear personal
protective equipment.
j) Hold power tool by insulated gripping surfaces, when
performing an operation where the cutting accessory may
contact hidden wiring or its own cord.
k) Position the cord clear of the spinning accessory.
l) Never lay the power tool down until the accessory has come
to a complete stop.
m) Do not run the power tool while carrying it at your side.
n) Regularly clean the power tool's air vents.
o) Do not operate the power tool near flammable materials.
p) Do not use accessories that require liquid coolants.
Kickback and related warnings
a) Maintain a firm grip on the power tool and position your
body and arm to allow you to resist kickback forces. Always
use auxiliary handle, if provided, for maximum control over
kickback or torque reaction during start-up.
b) Never place your hand near the rotating accessory.
c) Do not position your body in the area where power tool will
move if kickback occurs.