Kettle - Beem MF3450-A Manual De Instrucciones

NOTE: By pressing the button
NOTE: The start button (5) remains pushed down only when the appliance is
connected to the electricity.
4. Watch the toasting process. If the bread has already reached the desired browning
level before the end of the toasting process, press the button
5. When the toasting process has finished, the toaster ejects the toast automatically.
The start button (5) moves back up and the signal lamp on the button
6. Remove the bread from the toast slot (3).
NOTE: If you find the toast too light, toast the bread again on a lower setting.
Watch the toaster here to make sure that the bread does not burn.
WARNING: If the toasted product becomes stuck, unplug the mains plug and let
the toaster cool down. Carefully remove the toasted product so you do not
damage the toast slot (3) and the heating filaments.
7. Clean the toaster regularly as described in chapter 7.
Using the bun rack (4)
The bun rack (4) is used for heating up uneven pieces of bread, buns, croissants, bagels
etc.
1. Push the button (2) down to lift the bun rack (4) up.
2. Select a browning level in the lower to medium range on the control (25).
3. Push the start button (5) down. The signal lamp on the button
toasting process begins.
4. Stop the toasting process with the button
process.
5. If you no longer need to use the bun rack (4), push the button (2) up. The bun rack
(4) folds back down.
6.2

Kettle

Hints and tips:
The filter (12) in the spout of the kettle (11) prevents lime scale residue etc. being
poured out with the water.
If the water cools down without being used, simply switch on the appliance again and
the boiling process will begin again.
If the kettle (11) is removed from the base station (13) before or during the boiling
process, the water boiling process stops and is continued again when the kettle is put
back in place.
NOTE: If the kettle (11) is switched on by mistake while empty, the boil dry
protection switches off the appliance automatically. Let it cool down before you
fill it with cold water and switch it on again.
NOTE: To avoid overload at the power connection, the kettle (11) switches off
automatically when the toaster is switched on. As soon as the toaster is ready,
the kettle switches back on again automatically.
1. Remove the kettle (11).
2. Open the lid (6) by pressing the button (7) and fill the kettle (11) with the desired
amount of water (at least 0.5 litres and a maximum of 1.5 litres).
BEEM – Elements of Lifestyle
you can stop the toasting process at any time.
or wait until the end of the toasting
.
goes out.
lights up and the
28 / 88