Faucet Installation - Watts H2O-DWUF300 Instalación, Operación Y Manual De Mantenimiento

Faucet Installation

Gather and identify the faucet pieces
Step 1
- Fit the O-ring (A) into the groove at the bottom of the
faucet then place the escutcheon plate (B) and the
black rubber washer (C) on the threaded stem . (Parts
found in faucet parts bag) .
Step 2
- Insert the threaded stem through the hole in sink and
let it rest on the sink top .
Step 3
- From the underside of the sink, insert black locating
washer (D) followed with lock washer (E) and nut (F)
into the shank . Check orientation of faucet then
tighten the nut (F) securely .
Step 4
- Locate the 1/4" blue tube in the parts bag . The
tube has one straight end and one bent end . Grab
the following parts from the faucet parts bag and
place onto the straight end of the tube: the 1/4"
compression nut (I), plastic sleeve (H) (small tapered
end of sleeve must point to the end of tube), and
then insert the plastic insert (G) all the way into the
end of the tube .
Step 5
- Push the assembled tube into the threaded stem
until it stops . Slide the compression nut (I) and plastic
sleeve (H) until you can thread compression nut (I)
onto the faucet . Use a wrench to securely tighten the
compression nut (I) while continuing to push the tube
into the faucet .
Step 6
- Attach the bent, open end of the blue tube into the
right side of the system by pushing it into the quick-
connect fitting located behind the Granular Activated
Carbon Filter .
A
B
D
E
F
G
H
I
Item Description
A O-ring
B Escutcheon Plate
C Black Rubber Washer
D Black Locating Washer
E Lock Washer
F Nut
G Insert
H Plastic Sleeve
I 1/4" Compression Nut
Page 5
Parts List for Faucet
C