Panasonic WV-Q126A Instrucciones De Operación página 8

Step 3
Secure the safety wire angle (accessory) to the
anchor bolt (for connecting the safety wire),
and connect the safety wire (accessory).
Mount a nut so that the safety wire angle is
q
secured on the anchor bolt.
Disconnect the safety wire from the safety w
wire angle.
Engage the face marked
e
bolt.
Bend the face marked
r
Connect the safety wire to the safety wire
t
angle again.
Engage the nut from beneath, and secure
y
the safety wire angle with top and bottom
nuts.
Engage another nut from beneath to tighten
u
and secure the nut that was engaged from
beneath in y in a double nut fashion.
Anchor bolt
e Insert
w Disconnect
Safety wire
Mark q
Safety wire angle
* The nut is omitted in the illustration above.
<Image of safety wire connection>
8
q with the anchor
w.
Upper side
Mark w
r Bend
Lower
side
t Connect
Note:
• When the existing anchor bolt that has been
installed is used for connecting the safety
wire, the use of 2 spacer nuts is helpful.
Spacer nuts
Safety wire
Step 4
Attach the paper gauge (accessory) to the
camera mounting stage.
Fold the double-sided tape side of the
q
paper gauge at a right angle as shown in
the drawing.
Paper gauge
Peel off the backing from the double-sided
w
tape of the paper gauge.
Spacer nuts
Safety wire angle
Existing anchor bolt
Double-sided tape
Folding line