Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2. Desk Installation
2b. Hole Installation
Disassemble the desk clamp assembly and select the right
components for hole installation.
Base Plate
Attachment Screw
4mm Allen Key
Rubber Pad
Re-install the base plate with three retained attachment screws. Tighten securely.
Note: min. hole diameter =10mm (.4")
max. hole diameter =70mm (2.75")
Pad
Clamp Adjustment Screw
From below the desk, insert retained clamp adjustment screw through pad and up through the hole in the desk.
Thread screw by turning the knob into base plate but do not tighten completely at this time. Center the desk
mount assembly over the hole and then securely tighten screw.
5
13-04-174-93329B.indb 5
5/14/2013 1:30:18 PM
Tabla de contenido
