Packing Removal And Machine Positioning Operations; Packing Removal - CIBIN Alaska Manual

1.2 PACKING REMOVAL AND MACHINE POSITIONING OPERATIONS

We recommend unpacking the equipment as soon as it arrives in order to verify that it is complete and that it has not been dama-
ged during transport. Damage, if any, must be communicated immediately to the carrier, even in the event that such damage is
only found during installation. Damaged equipment may not, under any circumstances, be returned to the manufacturer without
prior to written warning and without the manufacturer's written consent.
GB

1.2.1 PACKING REMOVAL

For correct removal of packing, follow the sequence of steps (A....E), using the following tools: -crowbar;-screwdriver.
Delivered equipment includes supplied fittings.
A) Use the screwdriver to REMOVE the screws of the outer edge of the wooden crate, which fix the lid.
B) Use a crowbar at the corners of the crate to PRISE OFF the lid.
C) USE the screwdriver to remove the screws which fix the monobloc to the wooden crosspiece. Next, remove the crosspiece
from the crate. Take care to support the monobloc (Fig.1.2.1.a).
D) LIFT the monobloc, using ropes (of adequate strength), which should be anchored to the two eyelets and remove it from the
crate. Take care to balance of the monobloc (Fig. 1.2.1.b).
E) DO NOT place the monobloc directly on the ground in order not to damage it (e.g.: overflow pipe, condenser fins, etc....).
Fig. 1.2.1.a
Fig. 1.2.1.b
69