Fitting The Cutter; Airborne Noise; Handlebar Vibration - EMAK MZ2500R Manual De Instrucciones

IMPORTANT
All the parts in the gear box and transmission
are in an oil-bath; lay the power hoe down
and check the level of the oil using the cap
(fig. 19, part. A) and top up, if necessary,
through the cap.
The oil drain plug (fig. 20, part. B) is used to
change the transmission oil with SAE 80 W
Direction
of operation
ASSEMBLY AND DISMANTLING

FITTING THE CUTTER

The tool support shaft has a hexagonal
design for quicker fitting of the cutters.
- Clean cutter hubs and the tool support
shaft carefully; lubricate it to facilitate fitting
and removal.
- Slide the cutter and disc hubs onto the tool
support shaft or together and secure them
using the pins (fig. 21, part. P).
- During fitting, the cutters must be offset as
shown in fig. 21.
- The sharp part of the tines must always be
facing forwards.
- Before starting work, always check that
all the screws and bolts on the hoes are
secured tightly.
oil, tank capacity 1.1L. Check the level of the
oil every time you intend using the power hoe
and change it after 300 hours of operation
(for the motor, refer to the manufacturer's
instructions book)

AIRBORNE NOISE

Weighted, equivalent constant acoustic
pressure level at the driving seat measured
at 1 m from the handlebars and 1.6 m off
the ground.
Max. rating 81.5 dB(A).

HANDLEBAR VIBRATION

Weighted measurement according to ISO
5349.
Max. rating: 6.1 m / sec.2
Approximate data measured on the available
range of motors.
Descriptions and illustrations are not binding. The manufacturer
reserves the right to change technical specifications or the design
without notice.
30