Installation Steps - LUND 318093 Instrucciones De Instalación

Installation Steps

Select (1) Front Mounting Bracket. Hold the Front Bracket over the rocker panel bracket and line up the (2)
mounting holes. Secure the brackets to the vehicle using the included longer (2) 8mm x 30mm Hex Bolts, (2)
Bolts, lock washers, flat
2
The center and rear brackets are identical. Select (1) Center/Rear Bracket and repeat the procedure as described
in Step 2 to install it in the center mounting location, (Figure 3). NOTE: Install (1) mounting bracket at a time. Do
3
Remove the (3) screws holding end cap to board, (Figure 4). Carefully pull the end cap out of the extrusion, (Figure 5).
4
5
NOTE: Actual application may vary slightly from illustrations.
8mm Lock Washers and (2) 8mm Flat Washers, (Figure 2). Do not tighten hardware at this time.
washers
Rear
Slide a square head bolt into the upper slot of the extrusion as shown, (Figure 6).
Repeat for lower slot. Slide the bolts beyond the end cap mounting locations, (Figure 7).
Front
not tighten hardware at this time.
Figure 4
Figure 6
Page 2 of 3
Install the mounting brackets one at
a time over the factory rocker panel
brackets.
Figure 2
REPEAT STEP 3 FOR REAR
MOUNTING BRACKET LOCATION.
Figure 3
Figure 5
Figure 7