Vacuum Packaging Machine - Diamond VAX/33-L Manual De Instrucciones

VACUUM PACKAGING MACHINE

4
DISPLAY
1- On - off button
2- Button for vacuum in containers
3- Welding bar temperature program button. Press it for 3 seconds to view the menu. When the led (4) starts to
flash you can choose the temperature (1, 2 or 3 leds depending on the temperature increase or decrease: 1 is the
lowest level, 3 the highest). After welding temperature selection, it is necessary to wait for 3 seconds so that the
electronic card can set the new temperature.
4- Led
STARTING UP
Remove the machine from its packaging, arrange it on a work surface making sure it is stable.
·
It is important that all the four feet of the device rest on the surface to ensure that the lower part of the machine
·
closes properly. This will guarantee a correct air suction.
It is advisable to keep the machine packaging in case you need to deliver it to have it repaired.
·
Clean the machine Carefully before starting it up.
·
To clean the external body, wipe it with a damp cloth and then with a dry cloth. To clean the control panel use a
·
dry cloth only.
Never use acid or caustic products.
·
Insert the plug in the socket and keep the on-off button (1) pressed for 2 sec.
·
OPERATING MODES
VACUUM INSIDE BAGS
Following these instructions, it is possible to preserve foodstuff inside special bags.
Switch on the machine with the on
·
Open the mobile lid in the front part of the machine.
·
Place the bag with the product to preserve between the two inferior gaskets. During the stage make sure that the
·
edge of the bag has no gathers and that it leans on the plane.
Close the lid applying a slight pressure on the two lateral ends. Press it for a few seconds until the bag begins to
·
empty.
The machine starts automatically and it starts to suck up the air from the bag.
·
VACUUM IN CONTAINERS
This operating mode can be used to remove the air in containers without starting the sealing process.
Switch on the machine with the on
·
Open the mobile lid in the front part of the machine.
·
Place the end without gasket of the special pipe on the little nozzle near the welding bar.
·
Place the end with gasket of the special pipe on the lid of the provided container.
·
Push the button (2) without closing the lid.
·
The machine starts
·
The 3 leds (4) on the display flash in sequence.
·
At the end of the vacuum cycle, the machine stops without sealing.
·
1
off button (1).
off button (1).
3
2