Tabla de contenido
Idiomas disponibles
Idiomas disponibles
PRODUCT SPECIFICATIONS AND PARTS
Debris
Screen Cover
Debris
Screen
Power Plug
Control Panel
Display
E-4
Remote Control
Receiver Light
Air Outlet
Front Panel
Remote Control
Before operating
1. Select a firm, level and flat location for the heater/fan.
• For proper air flow, locate the unit at least 1 foot from any wall or furniture.
Handle &
• Make sure none of the grills are blocked.
Remote
NOTE: When switching on the appliance for the first time, allow it to run at
Control
full power for approximately two hours to get rid of any unpleasant odor.
Storage
2. Plug the power cord into a 120V AC outlet.
3. When moving the unit, always lift it by the handle.
Control Panel
When initially plugged in, there will be a "beep" and an orange IR light
will come on indicating that there is power to the unit. The unit will be in
standby mode. The light will remain lit until the unit is unplugged from the
electrical outlet or the manual power switch is turned OFF (O).
Confirm manual power switch located on the back of the unit is turned ON (I).
Press on/off control to turn the display on.
The display will show the current room temperature.
Select either Heater Mode or Fan Mode (see instructions below). After plugging in and turning on, the
default power mode is: Heater on with Low speed heat setting. The default temperature setting is 77°.
Heater Mode
1. Press the Heater Mode touch control.
Manual
2. Select low or high speed heat by pressing the heat mode touch control again.
Power
Switch
The display will show:
Low speed heat.
High speed heat. High speed will take approximately 30 seconds before the speed increases.
Select Desired Temperature
1. Press the automatic temperature touch control. The temperature display numbers will blink until set.
2. Press the arrows by each "mode" control to move the temperature up/down.
The temperature selection range is 59 - 95° Fahrenheit.
If a temperature below the room temperature is selected, the unit will not run.
Oscillation
Press the Oscillation Touch Control to allow the unit to rotate back and forth. The oscillation icon
will light on the display when in use. To stop the oscillation, press the oscillation icon again.
When the heater is in Automatic Temperature Control, the oscillation function will stop when the set
temperature is reached and resume when the heater turns back on.
Timer
Select the number of hours before the heater shuts off by pressing the timer touch control. The display
hours will blink until set. Use the arrows to select the number of hours. The timer range is 1- 12 hours.
The number of hours selected will appear with an "h".
NOTE: the display will show the room temperature. If the timer and the temperature are both set,
the display will rotate between the two at 30 second intervals.
OPERATING INSTRUCTIONS
E-5
Tabla de contenido
