geberit ECO 201 Instrucciones De Servicio página 19

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 53
Troubleshooting
Before the pressing operation
Operating status
No LED lights up
Green LED flashes
During the pressing operation
Operating status
Green LED flashes and
roller drive moves back to
its starting position
Operating instructions ECO 201
Ensure the diameter of the pressfitting matches the
1
diameter of the pressing jaw
2
Connect the pressing tool to the power supply
Place the pressing jaw onto the pressfitting, see the
3
operating instructions for the pressing jaws
Press the start button and hold it for about two seconds
4
until the automatic pressing function activates
5
Wait until the roller drive moves back automatically
6
Release the pressing jaw from the pressfitting
Cause
Actions
The mains cable is not
Connect the mains connector to the power
connected
supply
Mains cable or mains
Have the mains cable and mains connector
connector is faulty
checked by a trained electrician and have them
replaced if necessary by an authorised specialist
workshop
Locking pin is not
Press the locking pin in as far as the stop
pushed in correctly
Cause
Actions
Locking pin has come
• Check the locking pin for damage
loose
• Press the locking pin in as far as the stop:
• Press start button
• Check the pressfitting for leaks and repeat the
Signal tone sounds and red LED lights up
pressing operation if necessary
EN
19
Tabla de contenido
loading

Tabla de contenido