STEP 3
3-1. Place the other end cap (E) onto the spring tube set (A). NOTE: ASSEMBLE ON THE FLOOR.
STEP 4
4-1. Check that the twist tube (B) can easily slide up and down. NOTE: If needed, loosen the
twist tube (B) by twisting the OUTER tube COUNTER CLOCKWISE, be sure the white plastic
spiral is covered by the OUTER tube. NOTE: ASSEMBLE ON THE FLOOR.
NOTE: If tubes separate, reinsert the INNER TUBE into the OUTER TUBE with the white plastic
spiral opposite the transition ring. Slide the inner tube until it extends more than halfway
out past the transition ring, as shown below.
transition ring
Pg 9 of 28
A
B
outer tube
correct twist tube (B) assembly
cam nut needs to be
all the way down.
inner tube
E
(spring tube set)
A
tapered end at the bottom
B
loosen
plastic spiral
(800) 892-3986
white
IS02147-I3
