Handset Sound Signals; Troubleshooting Guide - THOMSON 28115 Serie Guia Del Usuario

Handset Sound Signals

Signal
A long warbling tone (with ringer on)
Three short beeps (several times)
Single beep every 7 seconds

Troubleshooting Guide

Caller ID Solutions
No Display
• The battery must be fully charged. Try replacing the battery.
• Make sure that the unit is connected to a non-switched electrical outlet. Disconnect the
unit from the wall and plug it in again.
• You must subscribe to Caller ID service from your local telephone company in order to
receive Caller ID records.
Caller ID Error Message
• This message indicates either the presence of noise on the line, or that an invalid
message has been sent from the telephone company.
Cordless Phone Solutions
No dial tone
• Check installation:
Make sure the base power cord is connected to a working electrical outlet.
Make sure the telephone line cord is connected to the base unit and the wall phone jack.
• Connect another phone to the same modular jack; if the second phone doesn't work, the
problem might be with your wiring or local service.
• The handset may be out of range of the base. Move closer to the base.
• Make sure the battery is properly charged (for 1 hours).
• Ensure the battery pack is installed correctly.

Meaning
Signals an incoming call
Page signal
Low battery warning